VMI Hybrid Multipliers Spacer

You are here:   VMI Home Page >  Rectifier Assemblies  > Custom Rectifier Assemblies      Contact Us

Below is a list of information that, if known and included, would help in the design process. Don't worry if you don't have all the information, but do tell us what you do know.

Sometimes you don't know what you don't know. Design is often an iterative process, so.....take good notes, take a deep breath, and dive on in.

Going through your local representative will be painless and helpful. Or contact Us us for a quotation.

The following information should be supplied - or at least the best 3 out of 8:

1) Drawing, sketch, or approx. size
2) Mounting requirements
3) Environment (storage and operation)
4) PIV or Transformer Voltage
5) Output and surge currents
6) Operating freq. and voltage rise times
7) Heat sink details (oil, air, forced air)
8) Processing requirements
(see VMI HRP101 and HRP102 for MIL-PRF-19500 type screening)

Typical"
PIV
Typical
Io
Typical
Isolation
Thermal
Imp (Typ)
Case
Style
Up to 10kV
10mA to 500mA
10kV
15°C/W
A
Up to 15kV
250mA to 1A
15kV
20°C/W
B
Up to 10kV
100mA to 1A
10kV
15°C/W
C
Up to 10kV
100mA to 1A
10kV
15°C/W
D


VMI can provide rectifier assembly packaging to suit your application. Any of the discretes listed on this web site can be used. Standard or custom packages can be adapted to interface with high or low voltage leads or connectors.
Sample Packaging - Lots to choose from, or, come up with your own. Or, if you like, we can design the packaging for you, based on your input.

Case Style A
Case Style A Packaging

Case Style B
<Case Style B

Case Style C
Case Style C

Case Style D
Case Style D

Last revised: 16 Feb 2017